SUMMARY
Commercial macaque cages often have the following deficiencies:
1. Animals living in lower-row cages receive considerably less
light than those living in upper-row cages. This introduces a
dependent variable which may bias scientific research data.
2. The vertical dimension of the cage lacks structures and hence
is inaccessible to the animal(s).
3. Socially housed animals are provided.no option(s) of temporary
visual seclusion from cage mates. This may trigger antagonism
associated with food competition.
Simple changes in cage design are described that ameliorate these
deficiencies and create a healthier, more species-adequate micro
environment for laboratory macaques.
INTRODUCTION
Cages for laboratory macaques are usually designed by technical
professions little or no knowledge of, nor experience with the
animals. The products are rather sterile structures that take
sanitary requirements rather than the species-typical needs of
the animal occupant into consideration. The design of the cage,
however, may have an impact on the individual animal's general
well-being and hence on the validity of research data collected
from it.
The present report describes simple technical improvements of
three common deficiencies of commercial macaque cages.
Dark lower-row cages
Laboratory macaques are usually housed
in rows of stacked cages, with animals in lower rows intrinsically
receiving less light than those living in upper rows1. From the scientific
standpoint, physiological data collected from lower-row caged
subjects may not be compared without reservation with data collected
from upper-row caged subjects because of the effects light exerts
on bodily functions, particularly on the neuro-endocrine system2-5. U.S. federal rules
regarding "specifications for the humane handling, care,
treatment, and transportation of nonhuman primates" stipulate
that "lighting must be uniformly diffused throughout animal
facilities and provide sufficient illumination to aid in maintaining
good housekeeping practices, adequate cleaning, adequate inspection
of animals, and for the well-being of the animals6". Lighting conditions
for lower-row caged subjects frequently do not meet this criteria.
A simple change in cage design ameliorates this inadequacy.
The solid side panels of lower-row cages are replaced by mesh
walls (Figure la). Mesh walls separating different animals in
adjacent cages are dense enough to make it impossible for the
animals to stick their fingers through them. Unlike the solid
side panels, mesh walls are permeable to the light that is reflected
from the walls of the room.
Replacing the light-impermeable panels of lower-row cages with
light-permeable mesh substantially increases the intensity of
light (Figures 1a and 1b). This not only creates a healthier environment
for the caged subject(s) thereby improving scientific methodology,
but it also permits better visual health checks and more efficient
cleaning of (previously dark) cage comers by animal care personnel.
![]() |
![]() |
| FIGURE 1a Lower-row cage with left side panel replaced by a mesh wall; light intensity in center of cage: 53 lux. | FIGURE 1 b Same cage as in Figure 1a before side panel was replaced by a mesh wall; light intensity in center of cage: 22 lux. |
Inaccessibility of vertical space
Access to the vertical space of their living area is probably
essential for the well-being of captive macaques as they show
a marked preference to remain off the floor on elevated sites 7-9. Commercial macaque
cages, however, usually provide the animals horizontal but no
accessible vertical space. Apart from clinging to the mesh ceiling
during fear-inducing situations, the animals have little opportunity
to make use of the upper portion of the cage. A properly installed
perch can overcome this deficiency.
In standard cages, perches are suspended diagonally with a slope
of approximately 15°. The lower end of the perch is attached
with a chain at the front frame of the cage (Figure 2), the upper
end rests loosely at the junction of the back and side wall of
the cage (Figure 2). This mode of installation increases the usable
cage space by opening up the vertical dimension.

In restraint cages, perches are mounted in such a way that the squeeze-back can be moved freely. To achieve this, a stainless steel sleeve is mounted over a hole cut into the squeeze-back and a socket mounted exactly in line with it inside the front of the cage (Figure 3).
![]() |
![]() |
Perches are installed high enough to permit
free movement of the anirnal(s) under it (Figure 2).
Single caged adult rhesus macaques spent approximately 1/4 of
their time sitting in an elevated position on the perch1. The perch is especially
useful to the animals when their cage is cleaned, offering a dry
place to comfortably sit while the floor is sprayed with water10.
Lack of privacy from cage mates
Commercial cage modules for groups of macaques usually provide
no visual barriers for temporary seclusion. A passage hole in
the cage-dividing panel(s) can correct this circumstance.
A rectangular opening with smooth edges is cut close to the back
- not the front - of the cage to break visual contacts between
cage mates during potentially competition-inducing situations
of feeding from the food boxes mounted at the front of the cage
(Figure 4). In squeeze-back compartments, the position of the
passage hole is determined by the pull rods of the restraint apparatus
(Figure 4).
A privacy panel not only is beneficial for the relationship between
cage companions10, but it also offers the animals a dry retreat while
the adjacent section of the cage is cleaned with pressurized water.

Acknowledgements
We are very thankful to Mrs. Annie Reinhardt for providing constructive
comments on this manuscript and to Mrs. Jackie KiDney for proof
reading it. This project was supported by NIH grant RR-00167 to
the Wisconsin Regional Primate Research Center. Publication number
32-030 of the WRPRC.
References
1. Reinhardt, V. (1989). Evaluation of the long-term effectiveness
of two environmental enrichment objects for singly caged rhesus
macaques. Lab. Animal, 18 (6),31-33.
2. Dewan, E. M. ( 1967). On the possibility of a perfect
rhythm method of birth control by pe light stimulation. American
Journal of Obstetrics and Gynaecolgy, 99, 1016-1019.
3. Dewan, E. M., Menkin, M. F., Rock, J. (1978). Effect
of photic stimulation on the human menstrual cycle. Photochemistry
and Photobiolgy), 27, 581-585.
4. Bowers, C. L., Elton, R. H. (1982). Synchronization
of menstrual cycles in pigtailed macaques using photoperiod. Journa/
of Medical Primatolgy, 11,252-256.
5. Wurtman, R. J., Axelrod, J., Kelly, D. E. (1968). The
Pineal. Academic Press, New York.
6. U.S. Department or Agriculture (1991). Animal Welfare;
Standards; Final Rule. Federal Register, 56, 6495-6505.
7. Bernstein, I., Mason, w. (1963). Activity patterns of
rhesus monkeys in a social Group. Animal Behaviour, 11, 455-460.
8. Rosenblum, L., Kaufman, I., Stynes, A. (1964). Individual
distances in two species of macaques. Animal Behaviour, 12, 338-342.
9. Reinhardt, V. (1992). Space utilization by captive rhesus
macaques. Animal Technology, 43, 11-17.
10. Reinhardt, V., Smith, M. D. (1988). PVC pipes effectively
enrich the environment of caged rhesus monkeys. Laboratory Primate
Newsletter, 27(3), 4-5.
11. Reinhardt, V ., Reinhardt, A. ( 1991 ). Impact of a
privacy panel on the behaviour of caged female rhesus monkeys
living in pairs. Journal of Experimental Animal Science, 34, 55-58.